[Obrzydzenie]

No kupiłem dysk na allegro 14TB recertyfikowany, wygląda że jest ok. Jak go dobrze sprawdzić w linuksie?
sudo smartctl --all /dev/sdb daje takie wyniki, wygląda to dobrze?

smartctl 7.2 2020-12-30 r5155 [x8664-linux-5.15.0-56-generic] (local build)

Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF INFORMATION SECTION ===

Device Model: OOS14000G

Serial Number: 000DCF1Z

LU WWN Device Id: 5 000c50 0c8c918ab

Firmware Version: OOS1

User Capacity: 14000519643136 bytes [14,0 TB]

Sector Sizes: 512 bytes logical, 4096 bytes physical

Rotation Rate: 7200 rpm

Form Factor: 3.5 inches

Device is: Not in smartctl database [for details use: -P showall]

ATA Version is: ACS-4 (minor revision not indicated)

SATA Version is: SATA 3.3, 6.0 Gb/s (current: 6.0 Gb/s)

Local Time is: Thu Dec 15 09:33:27 2022 UTC

SMART support is: Available - device has SMART capability.

SMART support is: Enabled

=== START OF READ SMART DATA SECTION ===

SMART overall-health self-assessment test result: PASSED

General SMART Values:

Offline data collection status: (0x82) Offline data collection activity

was completed without error.
Auto Offline Data Collection: Enabled.

Self-test execution status: ( 41) The self-test routine was interrupted

by the host with a hard or soft reset.

Total time to complete Offline

data collection: ( 567) seconds.

Offline data collection

capabilities: (0x7b) SMART execute Offline immediate.

Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.

SMART capabilities: (0x0003) Saves SMART data before entering

power-saving mode.
Supports SMART auto save timer.

Error logging capability: (0x01) Error logging supported.

General Purpose Logging supported.

Short self-test routine

recommended polling time: ( 1) minutes.

Extended self-test routine

recommended polling time: (1227) minutes.

Conveyance self-test routine

recommended polling time: ( 2) minutes.

SCT capabilities: (0x50bd) SCT Status supported.

SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.

SMART Attributes Data Structure revision number: 10

Vendor Specific SMART Attributes with Thresholds:

ID# ATTRIBUTENAME FLAG VALUE WORST THRESH TYPE UPDATED WHENFAILED RAWVALUE

1 RawReadErrorRate 0x000f 076 064 044 Pre-fail Always - 39749896
3 SpinUpTime 0x0003 093 090 000 Pre-fail Always - 0
4 StartStopCount 0x0032 100 100 020 Oldage Always - 13
5 ReallocatedSectorCt 0x0033 100 100 010 Pre-fail Always - 0
7 SeekErrorRate 0x000f 100 253 045 Pre-fail Always - 370604
9 PowerOnHours 0x0032 100 100 000 Oldage Always - 18
10 SpinRetryCount 0x0013 100 100 097 Pre-fail Always - 0
12 PowerCycleCount 0x0032 100 100 020 Oldage Always - 12
18 UnknownAttribute 0x000b 100 100 050 Pre-fail Always - 0

187 Reported

Uncorrect 0x0032 100 100 000 Oldage Always - 0

188 Command

Timeout 0x0032 100 099 000 Oldage Always - 4295032833

190 Airflow

TemperatureCel 0x0022 066 049 040 Oldage Always - 34 (Min/Max 33/36)

192 Power-OffRetractCount 0x0032 100 100 000 Oldage Always - 8

193 LoadCycleCount 0x0032 100 100 000 Oldage Always - 15

194 TemperatureCelsius 0x0022 034 051 000 Oldage Always - 34 (0 23 0 0 0)

197 CurrentPendingSector 0x0012 100 100 000 Oldage Always - 0

198 OfflineUncorrectable 0x0010 100 100 000 Oldage Offline - 0

199 UDMACRCErrorCount 0x003e 200 200 000 Oldage Always - 0

200 MultiZoneErrorRate 0x0023 100 100 001 Pre-fail Always - 0

240 HeadFlyingHours 0x0000 100 253 000 Oldage Offline - 16 (116 88 0)

241 TotalLBAsWritten 0x0000 100 253 000 Oldage Offline - 499812048

242 TotalLBAsRead 0x0000 100 253 000 Oldage Offline - 28220802

SMART Error Log Version: 1

ATA Error Count: 1

CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]

PoweredUpTime is measured from power on, and printed as

DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,

SS=sec, and sss=millisec. It "wraps" after 49.710 days.

Error 1 occurred at disk power-on lifetime: 3 hours (0 days + 3 hours)

When the command that caused the error occurred, the device was in an unknown state.

After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
04 51 00 00 00 00 00 Error: ABRT

Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC PoweredUpTime Command/FeatureName
-- -- -- -- -- -- -- -- ---------------- --------------------
00 00 00 00 00 00 00 ff 00:34:14.735 NOP [Abort queued commands]
b0 d4 00 82 4f c2 00 00 00:33:13.877 SMART EXECUTE OFF-LINE IMMEDIATE
b0 d0 01 00 4f c2 00 00 00:33:13.876 SMART READ DATA
ec 00 01 00 00 00 00 00 00:33:13.867 IDENTIFY DEVICE
ec 00 01 00 00 00 00 00 00:33:13.866 IDENTIFY DEVICE

SMART Self-test log structure revision number 1

Num TestDescription Status Remaining LifeTime(hours) LBAoffirsterror

# 1 Extended captive Interrupted (host reset) 90% 3 -

SMART Selective self-test log data structure revision number 1

SPAN MINLBA MAXLBA CURRENTTESTSTATUS
1 0 0 Nottesting
2 0 0 Nottesting
3 0 0 Nottesting
4 0 0 Nottesting
5 0 0 Not_testing

Selective self-test flags (0x0):

After scanning selected spans, do NOT read-scan remainder of disk.

If Selective self-test is pending on power-up, resume after 0 minute delay.

#linux #komputery #serwery

[wykopyrek]

@Obrzydzenie: nic mi się nie rzuca w oczy, zrób test wydajności hdparmem, narób dużych plików z urandom, niech polata trochę, w tym czasie rób regularnie testy smartem, żeby wyłapać jakieś zmiany

[Obrzydzenie]

@wykopyrek: też w szoku byłem, i to niecałe 900 zł

[Sunekkk]

@Obrzydzenie: zrób długi test, wykrywa większość problemów

smartctl -t long /dev/sdb

[Pan_Slon]

@Obrzydzenie: Daj ku… miodu tj przerzuć na dysk dużo danych i weryfikuj te dane. Dysk wadliwy, z zerowanym smartem, szybko się wyłoży/dane będą uszkodzone

[fabek]

@Obrzydzenie: i jak tam po roku chodzi ten dysk?

[Obrzydzenie]

@fabek ale #!$%@? trafiłeś xd właśnie wróciłem do PL. Wygląda na to że chodzi zajebiście, aż myślę kolejny kupić. Mogę zapuścić jakiegoś testa na noc tylko komendę mi podaj co mam w tym terminalu wpisać

[fabek]

@Obrzydzenie: smartctl --test=long /dev/sdX - gdzie X podaj litere jaka dysk dostal w dev

[Obrzydzenie]

@fabek dobra zapuszczę na noc, jutro się odezwę

[Obrzydzenie]

@fabek: no i zapomniałem, zapuściłem test teraz, ma się skończyć o północy

[fabek]

@Obrzydzenie: daj znac po testach

[Obrzydzenie]

@fabek: a powiedz mi gdzie szukać tego raportu?

[fabek]

@Obrzydzenie: w konsoli tam gdzie program odpalony

[Obrzydzenie]

@fabek: aha czyli wszystko poszło się #!$%@?ć?

sudo smartctl --test=long /dev/sdb

[sudo] password for:

smartctl 7.2 2020-12-30 r5155 [x86_64-linux-5.15.0-75-generic] (local build)

Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF OFFLINE IMMEDIATE AND SELF-TEST SECTION ===

Sending command: "Execute SMART Extended self-test routine immediately in off-line mode".

Drive command "Execute SMART Extended self-test routine immediately in off-line mode" successful.

Testing has begun.

Please wait 1227 minutes for test to

[Obrzydzenie]

@fabek: a dobra, znalazłem. Nie wiem jak to interpretować mam

smartctl 7.2 2020-12-30 r5155 [x8664-linux-5.15.0-75-generic] (local build)

Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org

=== START OF READ SMART DATA SECTION ===

SMART Self-test log structure revision number 1

Num TestDescription Status Remaining LifeTime(hours) LBAoffirst_error

# 1 Extended offline Completed without error 00% 916 -

# 2 Extended captive Interrupted (host reset) 90% 3 -

[Obrzydzenie]

Extended captive Interrupted (host reset)

@fabek: z tego co czytam to dysk się wyłączył bo nie był używany xd